Posts for: May, 2019
X-ray imaging is such an intricate part of dentistry, we usually don't think twice about it. Without it, though, the fight against dental disease would be much harder.
At the same time, we can't forget that x-rays are a form of electromagnetic radiation that can penetrate human tissue. It's that very quality and the difference in the absorption rate between denser bone and teeth and softer diseased tissue that makes disease diagnosis possible.
But this same penetrative power can potentially harm the tissues it passes through. For that reason when practicing any form of x-ray diagnostics, dentists follow a principle known as ALARA, an acronym for "As Low As Reasonably Achievable." In lay terms ALARA means getting the most benefit from x-rays that we can with the lowest dose and exposure time possible.
While practicing ALARA with x-rays is important for patients of any age, it's especially so for children who are more sensitive to radiological energy given their smaller size and anatomy. We can't use the same settings, dosages or exposure times with them as with an adult.
To protect children, dentists have developed techniques and protocols that lessen their exposure time and rate, while still providing usable images for diagnosing disease. The bitewing is a good example of safe and effective pediatric x-ray imaging.
A bitewing is a plastic device holding exposable film that patients bite down on and hold in their mouth while x-raying. The x-rays pass through the teeth and gums and expose the film behind them on the bitewing. Using a bitewing we can capture a set of two to four radiographs to give us a comprehensive view of the back teeth, while exposing the child less radiation than they normally receive daily from background environmental sources.
This and other advances in equipment and digital imaging greatly reduce the amount of radiation patients receive during x-rays. If, though, you're still concerned about your child's x-ray exposure, talk with your dentist who can explain in more detail the x-ray safety protocols they follow. Just like you, they want your child to be as safe as possible while still benefiting from the diagnostic power of x-rays.
If you would like more information on safety precautions using x-rays with children, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “X-Ray Safety for Children.”
The longer many health problems go on, the worse they become. Treating them as early as possible could stop or slow their development.
That holds true for poor bites: while we can certainly correct them later in life, it's often better to "intercept" the problem during childhood. Interceptive orthodontics attempts to do this with treatments that influence how the jaws and other mouth structures develop during childhood. Many of these techniques are usually best implemented before puberty.
For example, some very complex problems called cross bites can occur if the upper jaw grows too narrowly. We might be able to stop this from happening by using an orthodontic appliance called a palatal expander during the childhood years. It works because the bone at the center of the palate (roof of the mouth) has a gap running back to front until the early teens when the gap closes.
We fit the palatal expander up under and against the palate, then extend out metal arms from a center mechanism to the back of the upper teeth that exert outward pressure on them. This widens the center gap, which the body continually fills with bone as the device gradually exerts more pressure. Over time this causes the jaw to widen and lessens the cross bite. Timing, though, is everything: it's most effective before the gap closes.
Another way to aid jaw growth is a Herbst appliance, a hinged device that alters the movement of the jaws. As a child wears it, a Herbst appliance draws the lower jaw forward to develop more in that direction. Like the palatal expander, it's best used before significant jaw growth occurs.
These are just two examples of techniques and tools that can guide structural growth and prevent bite problems. Because they're most effective in the early years of oral development, your child should undergo an orthodontic evaluation as early as age 6 to see if they need and can benefit from an interceptive treatment.
Interceptive orthodontics can stop or at least slow a growing bite problem. The effort and expense now could save you much more of both later on.
If you would like more information on interceptive orthodontics, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “Interceptive Orthodontics: Timely Intervention can make Treatment Easier.”
Your teeth are sound and healthy—but appearance-wise, they're nothing to write home about. It's nothing major: a chip, some heavy staining or perhaps a slight gap between the front teeth. But whatever the blemish, it bothers you every time you look in the mirror.
There's an affordable way to improve your smile without a lot of extensive treatment: porcelain veneers. These thin layers of dental porcelain are bonded to the teeth's exterior to mask the blemishes beneath. All you and others can see, though, are beautiful teeth blending seamlessly with the rest of your natural teeth.
Changing your smile with veneers begins with a consultation with your cosmetic dentist. During your visit you'll discuss what you would like to improve and how you would like your smile to appear afterward. It's helpful to take along magazine photos or other images of how you'd like your teeth to look.
After making impressions and getting other necessary measurements, your dentist may then be able to show you what your new veneers will look like. One way is through computer software that superimposes your proposed new look onto a photograph of your face. Your dentist may also be able to create test veneers with acrylic or other dental materials and apply them to your teeth. These aren't your permanent veneers, but they can still give you a realistic view of your future smile.
Once your measurements are on the way to the dental lab to custom create your veneers, your dentist must prepare your teeth for bonding. Although veneers are quite thin, they may still appear bulky when bonded to the teeth. To create a more natural look, you'll probably need some of the enamel layer of your teeth removed to accommodate the extra width. Even though this is a small amount, it will permanently alter your teeth and require some form of restoration from then on.
After your veneers arrive, the dentist will attach them with a translucent cement that will bond them seamlessly to the natural teeth. You and others won't be able to see where the veneer ends and the natural tooth begins. What you will see, though, is a new look for your teeth and a more attractive smile.
If you would like more information on porcelain veneers, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “Porcelain Veneers: Strength & Beauty as Never Before.”